Adjusting The Headrest; Cleaning And Maintenance - ISOFIX ARKA Manual De Uso

5. fastenInG the chIld Into the seat GrouP 1.
1. loosen the harness straps by stretching the chest section while holding
down the harness adjustment button
2. open the buckle (fig. 5.1 and 5.2) and place the child into the seat.
3. Fit the safety harness around the child and connect the 2 parts of the
fastener, inserting them into the buckle until you hear a click (fig. 5.3)
which indicates that it is securely locked.
5. stretch the harness adjustment belt
the correct amount of tension. Remember that harnesses must be well-
tightened in order to guarantee the child's safety (5.4).
6. adjustInG the heIGht of the headrest and harness

adjusting the headrest

The correct adjustment of the headrest ensures that the child is properly
fastened into the car seat. The headrest must be adjusted so that the
harness is at shoulder height on the child or slightly above, but never
behind the back or at ear level (fig 6.2).
1. pull the headrest height adjuster
accordance with tshe size of the child (fig. 6.1).
adjusting the height of the harness
1. loosen the 5-point harness of the child seat as much as possible. Back
side of the child seat:
2. press the button of the shoulder belt height adjuster at the rear of the
seat shell and tilt the shoulder belt height adjuster towards you. (fig. 6.1).
3. slide the shoulder belt height adjuster to select the correct height of
the shoulder belts and engage it in the position that fits for your child by
releasing the button.
18
(e)
.
(f)
in order to give the harness
(a)
and move it to shoulder height in
7. fastenInG the chIld Into the seat GrouP 2 and 3.
removing harnesses and the safety buckle
(c)
Release the harness protectors
in place from the fastener at the back of the seat. // Release the straps
from the connector and remove them by pulling on them. // Turn the child
seat over and from underneath the seat, remove the harness straps by
passing the lock plate through the slot on the seat. The harness straps
will be released. // Remove the safety buckle from the seat
fastening the child into the seat
1. place the child seat on the car seat (fig. 7.1).
2. sit the child on the seat and then fasten the car seatbelt, inserting it
into the buckle until you hear a click. Ensure that the abdominal strap
goes underneath the armrests (fig. 7.2/B).
3. Thread the diagonal part of the belt through the diagonal belt guide
until it is securely in place (fig. 7.2/a). Make sure that it is not twisted.

8. cleanInG and MaIntenance

1. To wash belts and plastic parts, use neutral detergent and warm water.
2. Ensure that soap does not enter inside the buckle or metal pieces.
3. Do not use chemical products or bleach on any part of the child seat.
WashInG InstructIons:
- the cover can be removed and
- dry clean, any solvent
washed at 30 °c. It should only
except trichlorethylene.
be air-dried.
- do not use a dryer.
- Machine wash, cold.
- do not iron.
- do not use bleach.
If you have any doubts about using or installing this product, or you need a
replacement part, please get in touch with our customer service team.
by removing the straps that hold them
(d)
30 °C
19