Best WBF4I Manual De Instrucciones página 14

INSTALL THE HOOD (Non-Ducted Hoods Only)
NOTE: Non-ducted installations
require Non-Duct Kit, Model
ANKWBF4 (purchase
separately).
1. CAUTION: Do not use plastic
or rigid metal duct.
2. Do not remove the protective
plastic film covering the
decorative flue and the hood at
this time.
3. Lay the back side of the hood
flat on a table. Use a piece of
cardboard to avoid damaging
the table or the hood.
NOTE: Non-ducted installations
require Non-Duct Kit, Model ANKWBF4
(purchase separately).
1. CAUTION: Do not use plastic or rigid
metal duct.
2. Do not remove the protective plastic
film covering the decorative flue and
the hood at this time.
3. Lay the back side of the hood
flat on a table. Use a piece of
cardboard to avoid damaging the
table or the hood.
4. Attach damper / duct connector to
top of hood using (4) #8 x 3/8" Pan
Head mounting screws.
5. Remove damper flaps from
damper / duct connector and
discard flaps.
6. Remove the grease filters
by pushing down the metal
latch tab and tilting filters
downward.
7. Attach non-duct collar to non-
duct plenum using (4) #8 x
3/8" Pan Head screws.
8. Measure distance "A". This will
be the length of the extended
flex duct.
9. Attach aluminum flexible duct
to the damper / duct connector
with a tie wrap.
10. Attach flexible duct to non-duct
plenum collar and secure with
tie wrap. Tape all joints with
duct tape.
NON-DUCT KIT
MODEL ANKWBF4 CONTENTS
NON-DUCT
8 MOUNTING
PLENUM
SCREWS
(#8 x 3/8"
PanHead)
NON-DUCT PLENUM
COLLAR
WRAPS
(4) #8 X 3/8"
PAN HEAD
SHEET METAL
SCREWS
NON-DUCT PLENUM
6" ALUMINUM
FLEX DUCT
DAMPER / DUCT
CONNECTOR
- 14 -
NON-DUCTED
RECIRCULATION
FILTERS
2 TIE
FLEXIBLE DUCT
DAMPER / DUCT
CONNECTOR
4-7/8"
A