INSTALL THE HOOD
(Horizontally Ducted Hoods Only)
1. DO NOT REMOVE the protective
plastic film covering the decorative
flue and the hood at this time.
2. Lay the back side of the hood
flat on a table. Use a piece of
cardboard to avoid damaging the
table or the hood.
3. Attach damper / duct connector to
top of hood using (4) #8 x 3/8" Pan
Head mounting screws.
4. Remove the grease filters by
pushing down the metal latch
tab and tilting filters downward to
remove.
5. Carefully rotate hood upright.
6. Make sure there will be adequate
clearance between top of hood
and lower flue mounting bracket
for ductwork. Elbow must be
located below lower flue mounting
bracket.
7. Align the hood and center it above
the hood mounting bracket. Gently
lower the hood until it securely
engages the bracket.
8. With the hood hanging
in place, drill through
the both holes located
in the inside lower
back of hood using a
5/16" drill bit. Insert
the included drywall
anchors into the
drilled holes (one for
each hole). Install (2)
washers and (2) no. 8
x 1½" mounting screws
through the back of
the hood and into
the drywall anchors.
Verify that the hood is
centered and leveled.
Tighten all screws
completely.
9. Reinstall grease filters by aligning rear filter tabs with slots in the hood. push
down the metal latch tab, push filter into position and release. Make sure
filters are securely engaged after installation.
(4) #8 X 3/8"
PAN HEAD
SHEET METAL
SCREWS
LOWER FLUE
MOUNTING BRACKET
11½"
MAX.
I
NSIDE BACK
OF THE HOOD
S
IDE VIEW
H
OLES LOCATION
- 10 -
DAMPER / DUCT
CONNECTOR
M
/B
OTOR
LOWER
ASSEMBLY
Ø5/16"
.
TYP