Care And Maintenance - E/D/E 600 Manual De Instrucciones

Bedienungsanleitung · Operating instructions · Mode d'emploi
Istruzioni per l'uso · Gebruiksaanwijzing · Instrukcja obsługi
Manual de instrucciones
sufficient, or, when the platforms are lowered, the transport unit cannot lean against the furniture, these must not
be used to transport it.
Push the platforms of the units under the side faces (narrow side) of the piece of furniture until the upper and
lower supports are resting against it. The centers of the platforms must be beneath the center of gravity of the
furniture.
Place the securing straps in position with the edge protectors at the edges of the furniture. Pull the straps tight.
The straps will connect both units and, when used correctly, prevent them from slipping out of position. Wind up
the platforms about 1cm, and carefully check how firmly the piece furniture is standing on the platforms. It may be
that the transport units will have to be moved to another position.
Both platforms must be raised at the same amount.
For the transport itself, the height off the floor must be a maximum of 2cm only. When moving the furniture, only
push the transport units, and choose the way to the furniture ＇s new position so that, if possible, the furniture is
only moved lengthwise. When moving furniture sideways, always take the greatest care; there is a great risk of
the furniture tilting over. Avoid any jerky pushing movements.
The article being transported must not be left unattended standing on the equipment; it must always be lowered
onto the floor.
6.

Care and Maintenance

This Manual Furniture Mover only requires little care and maintenance, but this must be carried out regularly.
Depending on its use, the spindles and gear wheels must be re-greased weekly or monthly, using standard multi-
purse grease. For this, the spindle may be reached using a brush through the slot in the guide rail. The gear
wheels are also greased using brush, by first levering off the gear-housing lid with a screwdriver. The lid should
be pressed down firmly to close it again. The units 'function should be tested.
E/D/E GMBH · EDE PLATZ 1 · 42389 WUPPERTAL · GERMANY S E I T E | 9