Safety Instructions; Angle Adjustment - stayer B48PRK Manual De Instrucciones

Technical data
Battery charger Voltage and Frequency:
Voltage:
No load speed:
Bit size:
Battery type:
Charger current:
Charge time:
Read the following instructions and precautions before using this product. Store this manual in a
safe place.
User instructions
Range of use: Doing up an undoing screw. Use machine, changing unit and accessories (follow
maker's specifications) only for the specified range of applications! All other applications are
expressly excluded.

Safety instructions

- Do not use machines, attachments and chargers for works other than those for which they are
designed for.
- Before drilling holes or screwing into a wall, in case of doubt check with a metal-/voltage detec-
tor that you are not breaking into an electricity, gas or water supply line.
- Before you lay down the drill/screwdriver, make sure that all moving parts have come to a stop.
- Avoid frequent stalling when screwing or drilling, as it could damage the batteries.
- Only connect the charging device to a 230 V AC supply.
- Charge the screwdriver battery only with the appropriate charging device.
- The charging device and the screwdriver must be protected from moisture.
- Do not use the charging device in the open.
- Never expose batteries to temperatures above 50 °C.
- Warning: Do not short out the contacts of battery or charger.
- Respect the polarity "+/-" when charging.
- Do not throw batteries in fire.
Charging
The battery-operated screwdriver has not been fully charged at works. Before using for the first
time charge the screwdriver unit for 5-8 hours. To do this insert the charger plug (5) into the charg-
ing socket (4) and connect the charging. unit (6) to a power supply. The battery (9) is charged in
the screwdriver.
Care!
Do not exceed the maximum charging time of 8 hours, as there is a risk of overheating!
Reccomendation
Connect the unit up to a time switch.
Operation
Insert the screwdriver bit into the bit holder (3) as far as the stop. If standard bits or socket-head
bits are used, use an additional bit holder. Before switching on the screwdriver unit locate the
screwdriver bit firmly on the screw and switch on the unit to rotate in the desired direction (1),
push the Forward/Reverse Switch (1) to operate the screwdriver.

Angle adjustment

The screwdriver has 2 angle position adjustment, press the lock switch (11) to get the appropri-
ate angle position you need, the hinge allows the screwdriver handle to be angled for better
power transmission.
ENGLISH
B 48 PR CORDLESS SCREWDRIVER
230 V ~ 50/60 Hz
4.8 V
0-200 RPM
1/4"
4.8 V Ni-Cd
500 mAh
5 hours
7
110 V ~ 50/60 Hz
4.8 V
0-200 RPM
1/4"
4.8 V Ni-Cd
500 mAh
5 hours
7
120 V ~ 60 Hz
4.8 V
0-200 RPM
1/4"
4.8 V Ni-Cd
500 mAh
5 hours