Electrical Connection - CARLO GAVAZZI Guardian 1 Manual Original Del Usuario

Fig. 5 Use the self-adhesive drilling template for correct mounting holes and
cable connection
Pin assignment and colour code:
1 Pink [PK]
2 White [WH]
3 Green [GN]
4 Yellow [YE]
5 Red [RD]
6 Grey [GY]
7 Blue [BU]
8 Brown [BN]
Door control system connection:
Power Signal
Supply input
12-24 VAC safety
12-24 VDC sensor
(inside)
-
+
Guardian 1 inside
! Note:
Before switching on the unit, remove all objects from the detection area that
do not form part of the usual surroundings of the door. Also make sure that
nobody is within the motion area of the door during the teach-in phase.
The first time the sensor is powered up, all LEDs will form a running light. This
means that there is no valid presence zone stored into the sensor and the out-
puts are set at a safe state.
TEACH-IN
A: Open the door fully.
B: Store presence zone into the sensor by following step 1 and 2.
6

Electrical Connection

Not connected
Test input –
Test input +
Motion Output
Safe Output (presence zone)
Common output
– Supply
+ Supply 12 to 24 VAC/DC
Door control system
Motion Test
(radar) output
detector safety
input sensor
(inside) (inside)
-
+
Teaching the Presence Zone:
RIGHT
Cable plug front view
1 2 3
Power Signal Motion
Supply input (radar)
12-24 VAC safety detector
12-24 VDC sensor
(outside) (outside)
- +
Guardian 1 outside
4 5 6 7 8
Test
output
safety
input sensor
(outside)
-
+