HoMedics enviraScape MINI WALL Manual De Instrucciones E Información De Garantía página 3

CAUTION CONTINUED
• T he electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using this product immediately and return it to
the HoMedics Service Center for repair. (See the warranty section for
HoMedics address.)
• D isconnect the appliance from outlet before putting hands into water.
Figure 1
C. Fountain top
Clean water
Platform
A. Base
E. Light bulb
B. Pump
Package Contents
Part Description
A Base
B Pump
C Fountain Top
D River Rocks
E Light Bulb
F Power Adaptor
G Spare Light Bulb
4
D. River Rocks
F. Adaptor
Cord slot
Switch
Power cord
Quantity
1pc
1pc
1pc
1 bag
1pc
1pc
1pc
Assembly and Instructions for Use
Unpack the product. Be sure that all parts listed are included (Figure 1).
Familiarize yourself with the WATER PUMP (B) before completing assembly
of fountain. It is recommended the WATER PUMP be set as its highest
speed during assembly and later adjusted to a lower setting if desired.
The WATER PUMP speed is controlled by the switch located at the front of
the WATER PUMP (Figure 2).The speed is indicated by a plus(+) and minus
(-) sign. To increase the speed, move the switch slowly in the direction of the
plus sign. At its highest speed level, the switch will not move any further. To
decrease the WATER PUMP speed, move the switch toward the minus sign.
Similarly, at its lowest speed, the switch will not move any further. Once you
are familiar with the WATER PUMP, begin assembly.
Attention:
To get best results, please operate pump completely submerged. Keep the
water level above the minimum water level at ALL TIMES.
Figure 2
5
Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output