Dyna-Glo DGJ810CSB-D Manual De Instrucciones página 20

ASSEMblY INSTRUCTIONS
33. Open gas grill lid (C) and partially insert two
M6x30 screws (BB). Repeat for charcoal grill
lid (B).
Hardware Used
M6x30 Screw
bb
34. F rom the inside of the firebox (L), attach the end
of the warming rack (D) onto the screw (BB) and
tighten. Insert the bottom warming rack supports
into the holes located on firebox (L). Repeat for
charcoal grill lid (B).
35. I nstall three heat tents (G) into firebox (L).
WARNING: IT IS VERY IMPORTANT TO
CHECK AND ENSURE THAT THE SIDE
BURNER IS FULLY ENGAGED WITH THE
ADJACENT VALVE ORIFICE BEFORE
COMPLETING STEP 35. FAILURE TO DO
SO MAY RESULT IN FIRE OR EXPLOSION,
WARNING
Burner
Valve Orifice
x 4
POSSIBLY CAUSING
SERIOUS INJURY OR
DEATH. REFER TO
MAINTENANCE SECTION
INSTRUCTIONS TO
PROPERLY CHECK
THE ENGAGEMENT.
33
34
35
L
20
BB
L
BB
G
C
BB
D