Dyna-Glo DGJ810CSB-D Manual De Instrucciones página 25

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
Checking for leaks
After all connections are made, check all connections and fittings on the LP gas tank valve, gas hose
and regulator for leaks with a water and soap solution.
To prevent fire or explosion while testing for a leak:
• Always perform leak test prior to lighting the grill.
• Do not smoke while testing for a leak.
• Always perform leak tests outdoors in a well-ventilated area.
• Do not use any source of flame while testing for leaks.
• Do not use the grill until any and all leaks are corrected.
• I f you are unable to correct a leak, disconnect the propane supply and call a gas appliance service
dealer.
Perform leak Test
• P repare leak test solution by combining 1 part liquid dish soap with 3 parts water. Total solution
required is approximately 2 - 3 ounces (70 - 90 ml). Put leak test solution in a spray bottle.
• Ensure all control knobs are in the O "OFF" position.
• Open LP gas tank valve.
• S pray leak test solution on all gas carrying connections and fittings. Presence of bubbles at areas of
applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the
LP gas tank immediately and repair or replace the defective part. Do not use the grill until all leaks
are corrected.
Use only the regulator and hose assembly provided. If a replacement is necessary, please call our
customer service center. DO NOT use replacement parts that are not intended for this grill.
before First Use
Remove all hangings or plastic straps, if present.
Before you cook on your new gas grill, it is important to clean your grill with heat. To do this, operate
the grill for approximately 15 minutes with the lid closed and all main burner control knobs in the
highest position. This will clean the internal parts by burning off any residue and odor from the
manufacturing process. NOTE: Burn off is NOT necessary for side burner. Refer to the Operating
Instructions on Page 29 for more information.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knobs.
CAUTION
CAUTION
25

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido