HAMPTON BAY 52050 Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (II) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (HH) in the round
holes. This will enable you to remove the mounting bracket
(A).
A
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the setscrews (JJ) on the collar
on top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□
Carefully insert the hanger pin (CC) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (JJ) on the collar on top of the fan-
motor assembly (D).
2
Routing the wires
□
Make sure the slot openings are on top and route the
wires exiting the top of the fan-motor assembly (D)
through the canopy (C) and then through the ball/down-
rod assembly (B).
II
C
7
CC
Please contact 1-855-HD-HAMPTON for further assistance.
C
B
D
C
B
DD
JJ
D
HAMPTONBAY.COM