Trix 55 Serie Manual De Instrucciones página 7

Function
• Built-in electronic circuit for operation with a conventi-
onal DC power pack (max. ±12 volts), Trix Systems or
NMRA DCC digital systems.
• Automatic system recognition between digital and
analog operation.
• The full range of functions is only available under Trix
Systems and under DCC.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in
digital operation.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
Notes on digital operation:
• The operating instructions for your central unit will give
you exact procedures for setting the different param-
eters.
• The values set at the factory were selected to guarantee
the best possible running characteristics.
• This locomotive comes from the factory programmed
for the digital address „55" Number of speed levels that
have been set: 28.
• Correct programming with the 66920 Mobile Station is
possible starting with version number 034.
• The setting done at the factory does not permit opera-
tion with opposite polarity DC power in the braking
block. If you want this characteristic, you must do with-
out conventional DC power operation (CV29 / Bit 2 = 0).
Safety Information
• This locomotive is only to be used with the operating
system it is designed for.
• This locomotive must not be supplied with power simul-
taneously by more than one power source.
• Please make note of the safety information in the
instructions for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for thi-
spurpose. The interference suppression set is not suitable
for digital operation.
• Only the Trix decoder installed at the factory can be
plugged into the 21-pin connector.
7