RIB K Manual Del Usuario página 20

G
B
J1 DO NOT REMOVE ANY JUMPER! OTHERWISE THE
OPERATOR WILL NOT WORK!
J2 AERIAL Radio Antenna
LSC Close limit-switch that cuts off the motor in closing
LSO Open limit-switch that cuts off the motor in opening
COM Limit-switch common contact
PED BUTT Pedestrian opening contact (NO)
J3 L-N Main power supply 230 Vac 50/60 Hz (120V/60Hz upon
request)
J4 EARTH Connection of the earth line
J5 RADIO Built-in radio module (model CRX),
or connector for radio receiver RIB, 24Vdc supply
J6 A+ TEST 24Vdc safety strip self-test power supply
A+ Accessories power supply +24Vdc
A- Accessories power supply -24Vdc
COM + Common contact (common line for all the command and
safety inputs) (+)
K BUTT. Single pulse contact (NO)
PHOT. Photocells contact (NC)
EDGE Safety strip contact (NC)
Buzzer contact (24Vdc max 200 mA) (-)
-
J7 Flashing light (max 40W )
U - MOTOR Motor common connection
V-W - Motor phase and capacitor connections
MOTOR
J8 PROBE Temperature sensor cable connection PROBE (Code
ACG4665 optional)
RELAYS AND MOTOR COMMAND
K1 => Flashing light command
K2 => Closing command
K3 => Opening command
Q1 => TRIAC - Motor command in opening and closing
POINT B - SETTINGS
DIP 1 MOTOR ROTATION DIRECTION CHECK (See Point C)
DIP 2 PROGRAMMING (See Point D)
DIP 2-1 PROGRAMMING OF THE PEDESTRIAN OPENING (See Point D)
DIP 1-2 STORAGE/DELETION OF RADIO CODES FOR COMPLETE OPENING (DIP 1 ON
followed by DIP 2 ON) (POINT F) ONLY FOR CRX MODELS
DIP 1-3 STORAGE/DELETION OF RADIO CODES FOR PEDESTRIAN OPENING (DIP 1
ON followed by DIP 3 ON) (POINT G) ONLY FOR CRX MODELS
OPERATING MODE SETTINGS
DIP 3
ON - Automatic Closing ENABLED
OFF - Automatic Closing DISABLED
DIP 4
ON - Photocells active only in closing
OFF - Photocells always active
DIP 5 ON - blinker pre-flashing
OFF - blinker normal-flashing
DIP 6
ON - STEP BY STEP
Single pulse contact (K BUTT)
Pedestrian button (PED BUTT)
Radio Receiver command
OFF - AUTOMATIC
R1
R2 J1
R1 TRIMMER Electronic regulator for low speed on approach
LOW SPEED
R2 TRIMMER Electronic torque regulator
TORQUE
Single pulse contact (K BUTT)
Pedestrian button (PED BUTT)
Radio Receiver command
DIP 7
ON - electronic brake ENABLED
OFF - electronic brake DISABLED
FOR FAST VERSION code BA03221 - BA03177:
DIP 7 Electronic brake "weak version" (OFF)
Electronic brake "strong version" (ON)
DIP 8 ON - low speed in approaching DISABLED
OFF - low speed in approaching ENABLED
DIP 9
ON - gradual start ENABLED
OFF - gradual start DISABLED
DIP 10 ON - safety strip self-test ENABLED
OFF - safety strip self-test DISABLED
DIP 11 to select type of motor (see chart 1)
DIP 12 to select type of motor (see chart 1)
DIP 11 DIP 12 MOTOR TYPE
OFF OFF K800 - K1400 - SUPER 2200
ON OFF K5 - K500
OFF ON K2200
ON ON FREE FOR FUTURE APPLICATIONS
20
J3 J4
J2 J5
CHART 1
J7
J6
J8