jbc DR 3600 Guía De Referencia página 3

Solder tin deposit
Micro Desoldering tip
Heating element
Desoldering process
Use the tip model with a larger diameter than
the pad to be desoldered, so as to achieve
maximum aspiration and thermal efficiency.
1 Apply the Micro Desoldering iron tip so
that the component terminal penetrates
within its orifice.
2 When the solder liquefies, start gently to
rotate the Micro Desoldering tip so that the
component's terminal can be eased away
from the sides.
3 Press then, not before, the vacuum pump
push-button just long enough to aspirate
the solder.
1 2
After pressing the Micro Desoldering key there
is a slight delay until the self-contained vacuum
pump stops, this is to make sure that the
vacuum circuit is completely empty.
If any solder remains are left on any terminal
after attempting to desolder it, resolder it with
fresh solder and repeat the desoldering
operation.
DR 3600 Ref.3600000
Metal
Glass
Pushbutton vacuum pump
Fixing screw
3
Tip care
- The largest rod that fits in the tip hole should
periodically be passed through in order to
clean the intake tube.
- To clean the tips, use the sponge included
with the stand and check it is slightly
moisted.
Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water)
should be used in order to wet the sponge should be used in order to wet the sponge
should be used in order to wet the sponge should be used in order to wet the sponge should be used in order to wet the sponge.
If normal water was to be used, it is very
likely that the tip will become dirty due to the
salts dissolved within the water.
- Do not file the tips or use abrasive tools
which may damage the tip's protective
surface coating and avoid knocking them
about.
- If the tip has been a long time without
being tinned, use a metal brush to remove
any dirt and oxid.
IMPORTANT: : : : : DO NOT press the pushbutton
vacuum pump while tinning the Micro
Desoldering tip, as the fumes given off by the
flux would quickly soil the ducts and filter of
the air circuit.
2
ENGLISH
Vacuum hose
Micro Desoldering iron cable