ABB-Welcome
Pos : 40 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Übersc hriften (--> Fü r alle D okumente <--)/1. Ebene/G - L/Inbetriebnahme @ 11\mod_1279185496977_15.doc x @ 83035 @ 1 @ 1
7
Commissioning
Pos : 41 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Inbetri ebnahme/Di mmer/Inbetriebnahme - 6591 U-101 @ 19\mod_1311948781023_15.doc x @ 108300 @ 222 @ 1
The following components are required to operate the telephone gateway:
- ABB-Welcome door communication system including the system controller and at least one outdoor station.
- A PBX with analog input
- At least one telephone for configuring via DTMF
For the initial startup of the telephone gateway, a few basic settings need to be made.
Two options are available for commissioning:
1. Via telephone, connected to the system
2. Via Internet browser and IP-Gateway 83342-xxx. To configure the telephone gateway via the IP-Gateway,
please see IP Gateway manual.
7.1
Commissioning via telephone
1. Call the telephone gateway via your PBX
2. Enter Admin PIN
No.
Function
1
Enter Admin PIN
3. If the Admin PIN is correct, the telephone gateway enters the programming mode and the settings can be done as
followed:
No.
Function
Set default phone
1
number
2
Add a new Indoor
station to phonebook
3
Add a range of indoor
stations phone book
4
Add or change primary
and secondary phone
number
5
Add or change primary
phone number in the
phone book
Activate "Direct-accept"
6
feature
Deactivate "Direct-
7
accept" feature
8
Set New Admin PIN
9
Set New Master PIN
10
Activate mandatory
usage of indoor station
PIN
11
Deactivate mandatory
usage of indoor station
PINs
Command
[*] [*] [*] Admin PIN [#]
Command
[7] [3] [6] [*] Default phone number [#]
[2] [4] [7] [*] Indoor station number [#]
[2] [4] [7] [7] [*] Indoor station number 1 [*]
Indoor station number 2 [#]
[2] [*] Indoor station number [*] Primary phone
number [*] Secondary phone number [#]
[2] [*] Indoor station number [*] Primary phone
number [#]
[7] [3] [2] [1] [#]
[7] [3] [2] [0] [#]
[7] [*] [*] [*] New Admin PIN [*] [*] [*]
New Admin PIN [#]
[7] [*] [*] New Master PIN [*] [*] +
New Master PIN [#]
[7] [4] [7] [1] [#]
[7] [4] [7] [0] [#]
Example or explanation
The default Admin PIN is 1234
Example or explanation
The indoor station number can be 1
(or 01) to 250.
Indoor station number 2 must always be
greater than Indoor station number 1.
To be used if the user does not use
secondary phone number
If there are indoor stations in system, this
function should be activated.
— 9 —