Metra AX-ADGM03 Instrucciones De Instalación página 3

plug the aftermarket radio harness into
the aftermarket radio.
3. Reconnect the negative battery terminal.
Cycle the key by turning the ignition on for
30-seconds, then back off, then back on
again to test the radio.
Testing the AX-ADGM03
• Turn the ignition on, and then turn the
aftermarket radio on.
• Push the OnStar button, the radio should
turn off (radio will mute if mute wire is
connected) and you should hear OnStar.
Push the OnStar cancel button and the
radio should come back on.
Chime Volume Adjustment
1. With car on, shut off car and leave keys
in ignition. Open the car door and leave it
open. Chimes will be heard.
2. Wait 10-seconds, then with a small
screwdriver adjust the potentiometer
fully counterclockwise (all the way left),
then clockwise to raise chime level and
counterclockwise to lower the chime level.
3. When the volume is at the desired level,
AX-ADGM03
Installing the Interface
remove the keys from the ignition. This will
lock the chime volume at its current level.
Audio Level Adjustment
1. Start your vehicle and turn on the radio
having audio playing.
2. Turn your aftermarket radio's volume up
3/4 of the way.
3. With a small screwdriver adjust the
potentiometer clockwise to raise the audio
level and counterclockwise to lower the
audio level.
4. Once at desired level your audio
adjustment is complete.
OnStar Level Adjustment
To adjust the OnStar volume level find the
Black/Yellow wire on the 16-pin harness.
Push the blue OnStar button, while the voice
is speaking tap the Black/Yellow wire to
ground. Once the volume is set it will stay
at that volume until the Black/Yellow wire
is tapped to ground again. This can be set
during installation and then left alone. If user
adjustment is desired, the customer may also
tap volume up or down on the steering wheel
(if equipped) to adjust the OnStar level.
The XIA-LCD Screen (optional)
The XIA-LCD will allow you to navigate through factory installed
satellite options.
1. Channel up: Allows channel up function in satellite mode.
2. Channel down: Allows channel down function in satellite mode.
3. Select/Enter button: Selects current item on screen.
4. Escape/Exit button: Exits to previous screen.
5. Screen: This is where your satellite information is viewed.
Continued on back
3
5
1
3
2 4