Symbols Used - 3A HEALTH CARE MINIASPEED Battery Evo Plus Manual De Instrucciones

Type BF appliance
Carefully read the instructions before using this
device
The device's casing is protected against
solid particles having diameter of 1 mm
or above, spraying water and access to
hazardous parts with a wire
Switch On
Switch off (or battery on charge)
Direct current
additional notes in conformity with the IEC 60601-1-2/A1:2004-09 Standard
Emission test
Emissioni RF Cispr 11
Emissioni RF Cispr 11
Harmonic Emissions IEC
61000-3-2
Voltage fluctuations/ flicker
emissions IEC61000-3-3
MINIASPEED BATTERY EVO PLUS is intended for use in the electromagnetic environment specified below. The customer or
the user of the device should assure that it is used in such an environment.
Immunity test
Electrostatic discharge ± 6kV contact
(ESD) EN 61000-4-2
Burst/Fast Transient ± 2kV power supply
EN 61000-4-4 lines
Surge EN 61000-4-5 ± 1kV differentail mode
± 2kV common mode

SYMBOLS USED

Electromagnetic compatibility
Conformity
Group 1
Class B
Class A Conforming
Conforming
Test level
EN 60601-1-2
± 6kV contact
± 8kV air ± 8kV air
± 2kV power supply
lines
± 1kV differentail mode
± 2kV common mode
Alternate current
Do not use the unit when takig a bath or a
shower
0434
Thermally protected safety transformer
Disposable
EMISSION
Electromagnetic Environment - guidance
MINIASPEED BATTERY EVO PLUS uses RF energy only for its
internal function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic equipment.
MINIASPEED BATTERY EVO PLUS is suitable for use in all
establishments and those directly connected to the public low-
voltage power supply network that supplies buildings used to
domestic purposes. It is possible to use the device in all
establishments, including domestic establishments and those directly
connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes, adopting provisions
in the installation, such as a longer distance from potentially sensitive
appliances.
It is possible to use the device in all establishments, including
domestic establishments and those directly connected to the public
low-voltage power supply network that supplies buildings user for
domestic purposes.
IMMUNITY ASPECTS
Compliance Level
Floors schould be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
22
Conforms to Directive 93/42/EEC for
medical devices
The device contains a hermetic lead
battery. It must be disposed of in
accordance with current regulations
on the disposal of toxic-harmful
waste
Sterilisation by ethyl oxide
Electromagnetic environment - guide