Maintenance; General Maintenance - EGO CH2100E Manual Del Operador

CHARGING A HOT OR COLD BATTERY PACK
EN
If the battery pack is out of the normal temperature range, the red LED will shine and the
green LED will go off. When the battery pack cools down to approximately 57°C or warms
to more than 3°C, the charger will automatically begin charging.
DEFECTIVE BATTERY PACK OR CHARGER
If the charger detects a problem, the red LED will begin flashing and the green LED will
go off.
1. If registering as defective, remove and reinsert the battery pack in the charger. If the
LEDs still read "defective" a second time, try charging a different battery pack.
2. If a different battery pack charges normally, dispose of the defective battery pack
(refer to the instructions in the battery pack manual).
3. If a different battery pack also indicates "defective", unplug the charger and wait
until the red LED goes out, then reconnect the plug to the power supply. If the red
LED on charger still display defective, the charge may be defective.
WALL-MOUNT HOLES
The charger has hanging holes for convenient storage (Fig.1). Install screws in the wall
76mm apart. Use screws sufficiently strong to hold the combined weight of the charger
and battery pack (approximately maximum 3.3kg.)
14
56V CHARGER — CH2100E

MAINTENANCE

WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
WARNING:
When servicing, use only identical EGO replacement parts. Use of any
other parts may create a hazard or cause product damage.
WARNING:
It is not recommended to use compressed dry air as a cleaning
method of the charger. If cleaning with compressed air is the only method to apply,
always wear safety goggles or safety glasses with side shields when cleaning the tool.
If the operation is dusty, also wear a dust mask.
WARNING:
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
WARNING:
When servicing, use only identical EGO replacement parts. Use of
any other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician at an EGO
Service Center.
15
56V CHARGER — CH2100E
EN