Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Risk of unsafe operation. If engine does not start after two pulls, squeeze trigger of
gun to relieve pump pressure. Pull starter cord slowly until resistance is felt, then pull cord rapidly to
avoid kickback and prevent hand or arm injury.
11) Depress trigger on gun to start water flow.
Risk of unsafe operation. Stand on a stable surface and grip gun/spray wand firmly
with both hands. Expect the gun to kick when triggered.
12) Release trigger to stop water flow.
Risk of injury from spray. Always engage the trigger lock
when gun is not in use. Failure to do so can cause accidental spraying.
13) Adjust Variable Spray Wand for task, or change Quick Connect Nozzle
based on the task at hand.
SHUTTING DOWN YOUR PRESSURE WASHER
1) After each use, if you have applied chemicals, clean your chemical sys-
tem as described in How to Apply Chemicals / Cleaning Solvents section
on previous page.
Risk of Property Damage. Failure to clean chemical system could result in damage to
the pump.
2) Turn off the Engine. See Engine Owners Manual for complete details.
Risk of property damage. Never turn the water off with the engine running.
3) Turn off the water source.
4) Pull trigger on spray gun to relieve any water pressure in the hose or spray gun.
5) See Storage section in this manual for proper procedures.
Risk of burn hazard. When performing maintenance, you may be exposed to hot sur-
faces, water pressure, or moving parts that can cause serious injury or death.
Risk of fire hazard. Always disconnect spark plug wire, let engine cool, and release all
water pressure before performing any maintenance or repair. The engine contains flammable fuel.
Do not smoke or work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine maintenance sched-
ule should be prepared and followed. If the pressure washer is used in unusual conditions, such as
high-temperatures or dusty conditions, more frequent maintenance checks will be required.
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for any and all mainte-
nance. NOTE: The engine drain plug is located at the rear of the unit.
PUMP
The pump was filled with oil at the factory. The pump on this unit is maintenance free and requires
no oil. If there is a problem with the pump contact us at www.power-washer.us

MAINTENANCE

13
Trigger Lock Engaged

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido