Control Panel; Operation & Programming - Rointe 1000RAD Manual De Instalacion Y Uso

4. CONTROL PANEL

ON / STAND-BY button
MODE button
5. OPERATION & PROGRAMMING
5.1 ON / STAND-BY
When in STAND-BY mode the radiator does not heat up, but the
display will show the current time. Pressing the
seconds switches the product on or puts it into STAND-BY mode.
Press for 2 seconds to switch the product on. When it is switched
on for the first time, the time and day will flash. It's important to
configure these correctly in the next step.
5.2 Setting hour / day
The time and day must be set when you first switch the product on, or when the product
is disconnected and reconnected from the power supply.
It's also possible to configure this by pressing the
the product is in STAND-BY. The display will show the word "SET" and then suggests
changing the TIME and DAY of the week.
The time is set by holding down the
minute value is reached.
Click the MODE button to confirm the clock setting and continue to the day setting.
10
INCREASE button
DECREASE button
button for 2
MODE button for 5 seconds when
INCREASE button until the current hour and