Troubleshooting - Klarstein Olivia Manual Del Usuario

EN
20

TROUBLESHOOTING

Problem
Pressing shaft get stuck.
Motor stops working
without oil coming out.
Motor working without
oil coming out.
Motor stops by accident.
Hopper set at the wrong position.
Cavity lock buckle cannot
be set to right position.
Possible Solution
A: Press REVERSE button for
5-10 seconds , then press PAUSE/
START button to work again.
B: Pull off the plug, dismantle the cavity
and pressing shaft, clean out the left
residue from hopper and feeding hole,
then assemble to restart again..
A: It needs 30 seconds for
machine to be pre-heated.
B: Check if hopper and hopper
lid set rightly. (The hopper can
be set rightly only if cavity lock
buckle on the right position.)
A: Cavity protection cover has not
rotated to the right position.
A: check if the hopper without
material over 1 minute, please press
PAUSE/START button to restart
again if in protection proceed.
B: It would be in protection proceed
if keep working over 45 minutes
C: Check if big size material in the
hopper got stuck over one minute,
it would be in protection proceed
with this case. please restart the
machine, mix material with Muddle.
D: Check if hopper or hopper
cover in the right position.
A: Check if cavity lock buckle
in the right position.
A: Set the pressing shaft in the
hexagon hole first then the cavity.