STEP 1
Place the seat on its side. Insert (2) 6mm by 35mm
round head square neck bolts into the (2) holes in the
left side of the bottom of the seat.
6mm x 35mm
ITEM #18
STEP 2
While holding the bolts firmly in place fasten the
left seat supports to the bottom of the plastic seat
using (2) 6mm split lock washers and (2) 6mm
Nylock nuts.
Note: You cannot hand tighten Nylock nuts. An
adjustable wrench is required to complete this step.
ITEM # 20
6mm Split
Lock Washer
ITEM # 19
6mm Nylock
Nut