Bell BICYCLE CHILD CARRIER Manual De Instrucciones página 6

STEP 7
Remove the seat post clamp from your bicycle.
STEP 8
This step is for the 8mm hex bolt. Attach the
U-bracket using an 8mm by 58mm hex bolt, an
8mm split lock washer, and an 8mm Nylock nut.
Note: This step will require (2) adjustable wrenches.
Note: If the 8mm bolt doesn't fit, the following step
will show you how to use the included 6mm bolt
with spacers
ITEM #22 ITEM # 24
8mm x 58mm 8mm Split Lock
Hex Bolt Washer
ITEM #23 ITEM #17
8mm Nylock Plastic Thread
Nut Protector
STEP 9
This step is for the 6mm hex bolt. Insert the
spacers on the inside of the U-bracket. Attach the
U-bracket using a 6mm hex bolt, a 6mm split lock
washer, and a 6mm Nylock nut.
Note: This step will require (2) adjustable wrenches.
ITEM #15 ITEM # 20
6mm x 58mm 6mm Split Lock
Hex Bolt Washer
STEP 10
Slide the vinyl paint protectors over the (4) brackets.
STEP 11
Position the right and left seat supports on both
sides of the u-bracket.
ITEM #19 ITEM #16
6mm Nylock Nut Metal Spacer