PEERLESS SmartMount SF670 Manual Del Usuario página 7

For Flat Back Screen
Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit
2-1
for SF670 models or www.peerlessmounts.com/4 for SF680 models for a full screen compatibility chart for this
mount.
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (BB) into screen as
shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over
tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener
pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
2-2 Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit
for SF670 models or www.peerlessmounts.com/4 for SF680 models for a full screen compatibility chart for this
mount.
Begin with longer length screw, hand thread through multi-washer, adapter bracket (BB) and spacer in that order into
screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do
not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
SCREEN
ADAPTER BRACKET (BB)
SCREEN
SPACER
7 of 24
fig 2.1
MULTI-WASHER
SCREW
fig 2.2
MULTI-WASHER
SCREW
ADAPTER BRACKET (BB)
ISSUED: 11-09-07 SHEET #: 202-9253-2 10-13-08
www.peerlessmounts.com/3
www.peerlessmounts.com/3