Safety Information - Project Source F51B0061CP Manual Del Usuario

SAFETY INFORMATION

• Follow these installation instructions carefully. Proper installation is the installer's responsibility.
• Failure to follow correct installation procedures can cause the faucet to become loose, which can
result in serious injury.
• The product should be installed by a locally licensed plumber.
NOTE: Please DO NOT use plumber's putty on plastic components. Use silicone caulk if sealant is
required.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 12 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Silicone Sealant.
Helpful Tools (not included): Channel-lock Pliers, Safety Goggles.
• Prior to beginning installation, turn off the cold and hot water lines and turn on the old faucet to
release built-up pressure.
• When installing your new faucet, first, hand-tighten connector nuts. Then, use one wrench to hold
the fitting and a second wrench to tighten the nut an additional 1/4 turn. Connections that are too
tight will reduce the integrity of the system.
WARNING
This product is engineered to meet the EPA WaterSense flow requirement. The flow rate is governed by
the aerator or flow controller. If replacement is ever required, be sure to replace it with a WaterSense
compliant aerator or flow controller to retain the water conserving flow rate of this product.
3