Princess 242124 Manual De Instrucciones página 28

Press the start/stop button (2) to increase
the water hardness range by one level.
(Range 4 is followed by range 1, etc.)
Briefly press the on/off button (1) to save
the new water hardness range. If the on/off
button (1) is not pressed within ten seconds,
the appliance switches off automatically
without saving the setting.
Repeat the first two steps to check the
water hardness range.
Descaling (fig. A, B, C, K, L & M)
The appliance must be descaled regularly.
The appliance has an automatic descaling
indicator which informs the user when descaling
is required.
appliance must be descaled. It is still
possible to brew coffee and prepare hot
water, but frothing milk for cappuccino, latte
macchiato or café au lait is no longer
possible.
continuously, the descaling program is
running.
The automatic descaling program of the
durgol® swiss espresso®. The product is used
undiluted, is highly effective and guarantees a
reliable descaling and therefore a long
operational life of the appliance. The descaling
agent is available from our service station.
Warning! Be careful when descaling the
appliance to prevent damage to furniture or
clothing. Place an empty pot (at least 1.8 l)
under the coffee dispenser (10), the hot water
dispenser (11) and the milk froth dispenser
(12) in such a way as to prevent splashes.
Caution!
- Only use durgol® swiss espresso® in the
specified quantity to descale the appliance.
- Do not use vinegar or vinegar concentrate
to descale the appliance.
- Do not use citric acid to descale the
appliance.
Preparation
Press the on/off button (1) to switch off the
appliance.
Remove the dispenser cassette (9) from
the appliance.
Remove the milk frothing unit from the
appliance.
Manually remove the red steam valve (27)
from the steam outlet (30). If necessary, use
the hexagonal key (29) at the underside of
the coffee dispenser filter (28).
Remove the water reservoir (17) from the
appliance.
Remove the lid (19) from the water reservoir
(17).
Remove the cover (20) from the filter holder
(21).
Remove the anti-chlorine filter (18) from
the filter holder (21).
Put the red steam valve (27) in the filter
holder (21).
Place the cover (20) on the filter holder (21).
Make sure that the arrow on the cover (20)
points in the direction as shown (fig. B).
of durgol® swiss espresso®.
Place the lid (19) on the water reservoir (17).
Fill the water reservoir (17) with water up to
the maximum mark in the filling opening of
the lid (19).
Place the water reservoir (17) in the
appliance.
Part 1 - Descaling
Set the beverage selector (7) to position 'A'
or 'B'.
Insert the coffee pad cassette (13) into the
appliance.
Set the locking collar (8) to position 'A'.
Place an empty pot (at least 1.8 l) under
the coffee dispenser (10).
Press the on/off button (1) to switch on the
appliance.
Keep the on/off button (1) and the start/stop
button (2) pressed at the same time until the
pump starts to run. The descaling phase is
on as long as the descaling phase is running.
water level indicator (3) starts to flash.
28