Princess 242124 Manual De Instrucciones página 31

The steam indicator flashes and the start/
stop button remains illuminated red.
- Descale the appliance. It is still possible
to brew coffee and prepare hot water,
but milk frothing is no longer possible.
The milk is not suctioned.
- Rinse the appliance.
- Wait until the start/stop button illuminates
green and attempt to froth the milk again.
- Clean the red steam valve.
The milk froth does not develop.
- Make sure that the milk frothing unit is
assembled and mounted correctly.
- Manually tighten the red steam valve.
- Thoroughly clean the milk froth dispenser,
the flexible tube, the tube adapter and
the milk froth dispenser adapter.
The milk froth splatters extremely.
- Make sure that the milk frothing unit is
assembled and mounted correctly.
- Only use milk that comes directly from
the refrigerator.
- Allow the appliance to cool down
completely. Tightly screw the red steam
valve to the steam outlet.
The milk froth runs continuously.
- If you use a milk jug in which the milk
reaches higher than the milk froth
dispenser adapter, the milk jug is suctioned
dry after frothing milk: Make sure that
the milk jug is not higher than 14 cm.
The descaling program cannot be started.
- Keep the on/off button and the start/stop
button pressed at the same time. Release
the on/off button and the start/stop button
only when the pump is operating.
- Set the beverage selector (7) to position
'A' or 'B'.
The locking collar (8) cannot be set to
another position. No coffee emerges while
the pump is operating.
- Remove the mains plug from the wall
socket and leave the appliance for several
hours to reduce the pressure.
- Refer to the section "Emergency opening
for coffee pad cassette". Caution: coffee
may spray out during the process.
Disclaimer
Subject to change; specifications can be
changed without further notice.
31