MANUAL DE INSTRUCCIONES CODIGO 80369 REV 0
J
.P. SELECTA s.a.u.
JULIO/2018
8.3 Cleaning drainage filter
After a long time usage, some small impurity or particles could deposit on the draining
filter (26) and may affect vacuum and drying processes. The impurity could come from
grease, dust or dirty that the intruments to be sterilized or the water may contain.
To clean it, please do the following:
1. Locate the water filter
2. Rotate off the filter screw
3. Pull off the rubber filter from the connection
4. Take off the filter from the blue rubber
5. After you clean or change a new filter shim, plug in the water filter back on the
back chamber connection according to the photo, then tighten the scew nut.
6. Please turn the blue rubber to face down hard to touch the chamber
8.4 Replacing/cleaning the sealing ring
Extract the old ring. You will need a flat screwdriver to begin the extraction. Then,
insert the new ring easily with the hands.
1. Hold the edge of the seal with one hand and insert the screwdriver beneath the
seal with the other hand. Pull out the seal slowly.
2. Once a section of the seal is out, you may pull the whole seal out with both hands.
Then, clean the seal groove and the sea. It it is broken or damaged, replace it with
a new one.
3. After the groove and the seal are cleaned, mount the seal back in place.
Note: the seal should be mounted evenly inside the groove with first 4 positioning
points in place. You may use your hands to press the seal in place evenly.
4. When inserting the seal, the inner edge might evaginate. You may use a screwdriver
to press the edge down in the groove.
POWER THE MACHINE OFF AND LET IT COOL DOWN
AND AVOID ANY BURNING INJURIES
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: www.jpselecta.es
(Sujetas a modificaciones sin previo aviso)
BEFORE CHANGING THE SEAL
Pag.: 25
Tel 34 937 700 877 Fax 34 937 702 362