Publicidad
Step 8
Unfold the UPPER BACK (F) and lay it over your unit.
å
NOTE: Be sure the larger holes in the UPPER BACK are
å
positioned as shown.
Make equal margins along all four edges of the UPPER
å
BACK (F). Push on opposite corners of your unit if needed
to make it "square".
Fasten the UPPER BACK (F) to the LOWER BACK (E). Use
å
six BLACK 9/16" LARGE HEAD SCREWS (1S). Fasten the
top and both side edges of your UPPER BACK to your unit
using the NAILS (1N).
NAIL
(20 used in this step)
Page 12
F
1N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
E
417070
1S
Edge with
larger holes.
www.sauder.com/services
Publicidad
