Briggs & Stratton Simplicity Broadmoor Serie Manual Del Operario página 24

Maintenance
front-To-Back Leveling
6. Arrange the blades so they face front-to-back.
7. Measure the distance from the ground to the front tip of
the center blade, and from the ground to rear tips of left-
hand and right-hand blades.
Front tip of the center blade should be 1/4" (6 mm)
higher than rear tips of left-hand and right-hand blades.
If not, proceed with Steps 8 - 9.
8. 44" and 50" Mowers - To raise front of mower deck,
loosen front nut (a, Figure 22) and turn rear nut (B)
against bracket. To lower front of mower deck, loosen
rear nut and the bracket will move backwards to
lengthen rod.
B
figure 22
24
a
46" and 52" Mowers - Loosen the outside nut (a,
Figure 23). Turn the eccentric nut (B) to raise or lower
the front of the mower. When the mower is level, hold
the eccentric nut while tightening the outside nut.
9. Re-check the blade measurement then tighten the front
nut against the bracket to secure.
figure 23
a B