Pushing The Tractor By Hand; Adjusting Mower Cutting Height; Attaching A Trailer - Briggs & Stratton Simplicity Broadmoor Serie Manual Del Operario

Pushing the Tractor by Hand

1. Disengage the PTO and turn the engine off.
2. Pull the transmission release lever (a, Figure 7) back
approximately 2-1/2" (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
DO NOT TOW TRaCTOR
Towing the unit will cause transmission
damage. • Do not use another vehicle to
push or pull this unit. • Do not actuate the
transmission release valve lever while the
engine is running.
a
figure 7
en

adjusting Mower Cutting Height

The height-of-cut switch (a, Figure 8) adjusts the mower
cutting height. Press the switch UP to raise the mower
cutting height and DOWN to lower the mower cutting
height. The cutting height is infinitely adjustable between
1.0" and 4.0" (2,5 and 10,2 cm).
figure 8

attaching a Trailer

The maximum horizontal drawbar force allowed is 444
Newton. The maximum vertical drawbar force is 222
Newton. This equates to a 396 lbs (180 kg) trailer on a 10
degree hill. Secure the trailer with an appropriately sized
clevis pin (a, Figure 9) and clip (B).
B
figure 9
a
a
B
1 m
(3 pies
4 pulg.)
6 m (20 pies)
Operation
10°
17