Toyota AVALON 24870 Instrucciones De Installación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24870F
Wrenches: 10mm,13mm, 14mm
Drill Bits: None
op
FRAME BRACKET
SUPPORT
j
Qty. (8) BOLT, M8X1.25X30mm CL10.9
k
LOCK WASHER, 5/16"
Qty. (8)
l
FLAT WASHER, 5/16"
Qty. (8)
m
Qty. (4) BOLT, M10X1.50X35 CL8.8
LOWER MUFFLERS BY REMOVING RUBBER ISOLATORS, (2) ON DRIVER'S SIDE AND (3) ON PASSENGER SIDE. SUPPORT
1.
EXHAUST AS REQUIRED.
2. REMOVE (2) REAR MOST MUFFLER SUPPORT BRACKETS (3) BOLTS PER BRACKET. RETURN TO CUSTOMER.
3. REMOVE THE HEAT SHIELDS, (3) SCREWS PER SHEILD.
4. REMOVE TAPE COVERING WELD NUTS ON EACH SIDE OF FRAME RAILS.
5. LOOSELY INSTALL FRAME BRACKET SUPPORTS ON OUTBOARD SIDE OF FRAME RAILS WITH FASTENERS AS SHOWN.
6. RAISE HITCH INTO POSITION AND LOOSELY INSTALL THE M10 BOLTS. THIS WILL HOLD THE HITCH UP TO EASE
INSTALLATION OF THE M8 FRAME BOLTS AS SHOWN.
7. TIGHTEN ALL FASTENERS TO RECOMMENDED TORQUE.
8. REINSTALL HEAT SHIELDS AND RAISE MUFFLERS BACK INTO POSITION. USE MUFFLER SUPPORT RODS ON HITCH TO
REATTACH THE RUBBER ISOLATORS.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2011 Cequent Performance Products
Installation Instructions
TOYOTA AVALON
BUMPER
Drawbar Kit:
3593
Drawbar must be used in the
RISE position only.
l k j
Tighten all M8 fasteners with torque wrench to 27 Lb.-Ft. (37 n*m)
Tighten allM10 fasteners with torque wrench to 42 Lb.-Ft. (57 n*m)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
2000 LB (908Kg) Max Gross Trailer Weight
200 LB (91 Kg) Max Tongue Weight
Wiring Access Location: PC3, PC4
EXISTING
WELD NUTS
FRAME
l k
n m
n
FLAT WASHER, 3/8"
Qty. (4)
o
LOCK WASHER, 7/16"
Qty. (4)
p
Qty. (4) NUT, M10X1.50 CL10
q
Qty. ( )
Sheet 1 of 3 24870N
Part Numbers:
24870
60287
77253
j
FRAME BRACKET
SUPPORT
05-27-11
l k j
op
Rev. B