Parameter Settings - SATA 02002A Manual Del Uso

3.3 Parameter Settings

3.3.1 Password Setting
* The default password of the soldering station is "000", and temperature setting of soldering station is available under this state. To limit
the permission for temperature adjustment, change the password.
1） Enter the password change mode:
Turn off the power switch on the soldering station, press and hold the " △ " and " ▽ " keys at the same time, and press the
power switch to connect the power supply, and then display shows
modification mode.
2） Enter the default password correctly:
After entering the password change mode, press the key once to display
enter the default password and then press the * key.
a. When the entered password is wrong:
The display shows the current set value for about 4 seconds, and then the soldering station returns to the normal working state.
Since the entered password is wrong, you cannot set the temperature（Set Temp）.
b. When the entered password is correct:
If the display shows
seconds, and then the soldering station returns to the normal working state, , and you can set the temperature（Set Temp）.
3） Enter a new password:
Only when the two passwords you entered match can the new password be saved in the memory of the soldering station and the
password be changed successfully（the specific operation is as follows）
a. Enter your new password for the first time:
When the password entered is correct, the window displays
seconds, and then the
appears on the window. Press the " △ " or " ▽ " key to change the entered password.
b. nter your new password for the second time:
Press "*" again, and then the window displays
time. Press "*", and then the window display the
c. When the two passwords you entered match:
If the new passwords entered in the last two times are the same, press the "*" key. Then, the password will be changed
successfully and the new password will be saved in the memory.
d. When the two passwords you entered does not match:
If the passwords entered in the last two times are different, press the "*" key, and then the window will display the
this case, you must enter a new password again until the passwords entered in the last two times are the same; otherwise, the
password cannot be changed successfully.
3.3.2 Temperature setting
Note:
* Only when the temperature adjustment of the soldering station is available can the temperature be set（the default
password is 000, or the correct password is entered under the password protection mode）. Press the " △ " and " ▽ " keys
to set the temperature.
* If you turn off the power switch while setting the temperature, the set temperature will not be saved.
Caution:
When the temperature of the soldering bit is above 500 ° C, it is likely to damage the soldering iron. Set the temperature as low
as possible.
24
02002A
, it means the entered password is correct. The display will show the current set value for about 4
appears, indicating that you can input a new password now. Press the "*" key, and then the
中文
, indicating that the machine enters the password
. At this time, press the " △ " or " ▽ " key to
. Press the "*" key and " ▽ " key simultaneously within 4
, indicating that you need to enter the new password for the second
; and press " △ " or " ▽ " to enter your new password.
EN DE RU KO PT JA ES
. In