Replacement Of Fuse - SATA 02002A Manual Del Uso

4.4.4 Testing of heating element
1） Measure the resistance from pin 4 to pin1/pin 2, pin 5 to pin 1/pin2, pin 3 to pin 1/pin2, and pin 3 to pin XX/pin 5. If the measured
resistance is not ∞ , the heating element may contact he sensor or the vibration switch, which may damage the printed circuit
board.
2） Measure the resistances "a", "b" and "c" to ensure that the lead wires are not twisted and the ground wire is properly connected.
Heating element（white）

4.4.5 Replacement of fuse

1） Unplug the power plug from the power socket and remove the fuse cover.
2） Take out the broken fuse and replace it with a new one.
3） Put on the fuse cover.
32
02002A
Sensor（red "-" and blue "-"）
Vibration mode
中文
EN DE RU KO PT JA ES