1
Press the SOURCE button repeatedly to select TUNER
mode.
Select FM or AM by pressing the BAND button repeatedly.
2
Select the desired tuning mode.
3
Each time the TUNING MODE button is pressed, the tuning mode
changes as follows:
Manual tune
Auto tune
Preset tune
4
Select the station you want to listen to.
Listening to FM/AM
1 2
3
4
Manual tuning mode
Turn the TUNING/SELECT knob until the station you want to listen
to is found.
On the remote control, press ˙ or ¥ repeatedly.
The frequency changes by a fixed step (FM: 50 kHz steps, AM: 9
kHz steps).
Auto tuning mode
Turn the TUNING/SELECT knob to begin auto tuning.
When a station is found, the unit tunes in the station
automatically. Repeat this step until the station you want to listen
to is found.
< Press the ENTER button to stop the auto tuning.
Preset tuning mode
Turn the TUNING/SELECT knob to select a preset channel.
On the remote control, press .m or ,/ repeatedly.
The selected preset channel is tuned in.
FM Mode
Pressing the FM MODE button alternates between Stereo mode
and Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and "ST" is displayed.
Mono:
Select this mode when the signal is weak. Reception will be
forced monaural, reducing unwanted noise.
FM/ST
10:00
108.00MHz
23