Publicidad
Idiomas disponibles
Idiomas disponibles
STANDARD EQUIPMENT:
WEIGHT (without batteries)
TIRES (4 ply rated)
TIRE PRESSURE
LOAD CAPACITY
GROUND CLEARANCE
MAXIMUM HEIGHT
CHASSIS
BODY AND FINISH
SAFETY
LIGHTING PACKAGE
CONVENIENCE
STEERING WHEEL
BRAKES
FRONT SUSPENSION
REAR SUSPENSION
STEERING
DASH PANEL
SEATING
MOTOR
DRIVE TRAIN
ELECTRICAL SYSTEM
SPEED CONTROL
TRANSAXLE
SPEED
CHARGER
NOISE
VIBRATION, WBV
VIBRATION, HAV
Specifications subject to change without notice
* Do not use low inflation pressure tires on any E-Z-GO vehicle. Do not use any tire which has a recommended inflation
pressure less than the inflation pressure recommended in Owner's Manual
INDUSTRIAL
809 lbs. (374 kg)
18 x 5.70 x 8 (4 ply rated)*
35 - 45 psi (241 - 310 kPa)*
1000 lbs. (454 kg) (including operator, passenger, cargo bed and accessories)
4.75 in. (12 cm) at differential
65 in. (165 cm) with top
Welded high yield strength tubular steel with powder coat paint
Front: Flexible, impact resistant panels. Color coat/clear coat finish
Rear: Replaceable steel panels
Dash mounted key switch, reverse warning indicator, 'deadman' accelerator control, integral
handgrip on hip restraints, manual forward/reverse selector with 'neutral', electric horn
Dual halogen headlights
State of Charge meter, Hour meter
Dual handgrips and pencil holder integrated with clipboard
Dual rear wheel mechanical, self-adjusting drum brakes. Combination service / park brake with
automatic parking brake release (accelerator kick-off)
Heavy duty leaf springs with hydraulic shock absorbers
Heavy duty leaf springs with hydraulic shock absorbers
Self-compensating single reduction rack and pinion
Scuff resistant with four drink holders
Formed fabric backed vinyl covers over cushion foam. Seating for operator and one passenger
48 volt DC high efficiency shunt wound, brazed armature, solid copper windings
Direct motor shaft connected to transaxle pinion shaft
48 volt DC, eight, 6 volt deep cycle storage batteries
Solid State continuously variable speed controller, 400 amp rated
High efficiency differential with helical gears, 14.7:1 ratio
13 ± .5 mph (21 ± .8 kph)
Fully automatic line compensating, 48 volt output
For locations outside US and Canada, refer to charger manufacturer for specifications and
recommendations.
Sound pressure; continuous A- weighted equal to or less than 70db(A)
The highest RMS value of weighted acceleration is 1.17 m/s²
The highest RMS value of weighted acceleration; less than 2.5 m/s²
The uncertainty of measurement is 0.2 m/s²
Owner's Manual and Service Guide
GENERAL SPECIFICATIONS
™
1000
Page 31
Publicidad
Capítulos
