Configurating Parameters - Teltronic RP-30SB VHF Manual Del Usuario

6.3.- CONFIGURATING PARAMETERS

By means of the microswitches present at the control board (see annex 1),
another repeater functions can be controlled:
Tail timing
The repeater is designed to maintain the transmission condition even up to 8
seconds after the input signal has finished.
If there is a new access during this period of 8 seconds, the transmission will
go on. In this way it is avoided that little signal "fading" can influence the
repeater working as well as the present communication can be protected
from other access attempts.
The tail time can be selected among these values:
E
0
0
1
1
GB
F TAIL TIMING
0 0 SECONDS
1 1 SECOND
0 4 SECONDS
1 8 SECONDS
- 36 -