Lubricating The Bar Tip Sprocket; Battery Connectors - Husqvarna 436 Li Manual De Instrucciones

Power trigger lockout
• Make sure that the power trigger is locked at the idle
setting when the power trigger lockout is released.
• Press the power trigger lockout and make sure it
returns to its original position when released.
• Check that the power trigger and power trigger lockout
move freely and that the return springs work properly.
• Activate the chain saw and apply full power. Release
the power trigger and check that the saw chain stops
and remains stationary.
Chain catcher
Li-ion Li-ion
• Check that the chain catcher is not damaged and is
firmly attached to the body of the chain saw.
36 – English
MAINTENANCE
Keypad
• Activate the chain saw (green LED on) and make sure
the chain saw deactivates when the start/stop button
is pressed (green LED off).

Lubricating the bar tip sprocket

• Lubricate the bar tip sprocket each time you refill with
saw chain oil. Use the special grease gun and a good
quality bearing grease.

Battery connectors

Clean the battery and the machines battery compartment
with a soft brush after use. Make sure all cooling slots and
battery connectors are cleaned.
Li-ion Li-ion