Arneg Lisbona 2 Guía De Instalación Y Manejo página 47

Cabinet delivery • make sure the packing is intact and that it does not display readily apparent
• carefully perform the unpacking operati on in order not to damage the cabi-
• check that cabinet components are intact
• should you noti ce any damage immediately inform the manufacturer
Installati on pro-
cedure (Fig.5)
What to avoid
First cleaning • gently remove the protecti ve fi lm, eliminate glue residues with suitable sol-
• use neutral products, dry with a soft cloth
ATTENTION!: failure/breakage.
DO NOT walk on cabinet's roof (Fig.18).
CAUTION! Discarded packing parts. Injury.
Do not leave packing parts (nails, wood, staples, etc.) and tools used for the operati on (pliers,
scissors, etc.) in the working area.
These objects must be removed with appropriate means and taken to their respecti ve col-
lecti on places.
i
For correct disposal, the package consists of:
Wood - Polystyrene - Polythene - PVC - Cardboard.
05060167 00 09-08-2016
damages;
net;
carefully examine the installati on area, eliminati ng any danger to the
operator;
remove the package only if the cabinet is placed in the operati on area
Step
1 lift the cabinet safely
2 use suitable scissors to cut the clip ti ghtening straps-A-
3 remove the clips and the frame
4 lower and place the cabinet in the area of use
7 adjust the horizontal positi on of the cabinet using a spirit level (Fig.9)
8 check that all feet are into contact with the fl oor
9 level the cabinet both in front and back
Install maximum 3 cabinets within the same power supply and cooling
line
Should you need to move the cabinet, the latt er must be levelled again.
Incorrect levelling
i
To mount/unmount the back panels rotate the fastener B(Fig.22)
DO NOT install the cabinet (Fig.11):
- in areas at risk of explosion
- in open air and therefore subjected to atmospheric agents;
- near heat sources (direct sunlight, heati ng systems, incandescence lamps,
etc.)
- in the vicinity of air currents (close to doors, windows, air-conditi oning sys-
tems, etc.) that exceed a speed of 0.2 m/s
vents
DO NOT use alcohol to clean the methacrylate (Plexiglas) parts
DO NOT use abrasives or metal sponges
Acti on
Lisbona 2
English
43