Key To Symbols; Symbols On The Machine - Husqvarna 445 II Manual De Instrucciones

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use can
result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any object
must be avoided.
Recommended cutting
equipment in this
example: - Bar length 15
inches - Max. nose radius
10Teeth - Chain type
Husqvarna H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value
without triggering the brake, for the bar and
chain combination on the label.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
1155359-49 Rev.4 2017-05-03

KEY TO SYMBOLS

Refuelling.
Chain oil fill.
Air purge.
Adjustment of the oil pump.
Chain brake, activated (right) Chain
brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
The engine exhaust from this product
contains chemicals known to the State
XX
XX
of California to cause cancer, birth
defects or other reproductive harm.
–
English 7