Bosch 0 986 612 997 Instrucciones De Servicio página 13

Perform the pressing-in procedure as specified and described in the
corresponding repair instructions or data sheets.
The product-related information on the ESI[tronic] must be observed!
Following the pressing-in procedure, press the peak value key [ S ] twice.
The light emitting diode [ MAX ] goes out and the [ Tara ] LED goes on
again.
To perform another pressing-in procedure mount the corresponding
components (housing, bushing, press-in tool) onto the force-measurement
device 0 986 612 878.
Additional sequence: Return to start of Section 12.2.
Important!
Upon completing work with the manual indicator always use the
On/Off switch (1) on top of the device to switch off!
The On/Off key [ Ein/Aus ] on the membrane keyboard
only switches in the no-load current mode!
13