LD-3010 Series
Read this entire installation manual to ensure proper installation.
When finished with the installation, file this manual with the owner or
Installation
maintenance department. Compliance and conformity to local codes
and ordinances is the responsibility of the installers.
Separate parts from packaging and make sure all parts are accounted
Packing List
•
for before discarding any packaging material. If any parts are
•
•
missing, do not begin installation until you obtain the missing parts.
IS
T H
•
E
S ID
U P
Make sure that all water supply lines have been flushed and then
completely turned off before beginning installation. Debris in supply
lines can cause valves to malfunction.
Turn OFF electrical power to the electrical outlets, then unplug all
electrical units prior to installation. Electrical power MUST remain off
until installation is complete.
Installer's hardware must be appropriate for wall construction. Wall
anchors must have a minimum pull-out rating of 1,000 lbs.
For standard height mounting, do not exceed the recommended 34"
distance from the top of the lav deck to the finished floor. To meet
ADA requirements, the lav deck cannot exceed the 34" maximum
height dimension.
Product warranties may be found under "Products" on our Web site
at bradleycorp.com.
Supplies Required:
• ½" nominal copper tubing for hot and cold supply piping and 1½" NPT drain piping
• Silicone caulk/sealant for sealing between deck and walls
• For optional mounting brackets:
• For optional carrier sleeves: in-wall carrier sleeves by others (Josam model #17100-203 or equivalent
recommended; refer to the table below for carrier sleeve requirements) .
• For optional stainless steel trap cover: four #10 wall anchors and mounting fasteners (for each cover) suitable
for wall construction
Model #
LD-3010 30"
LD-3010 60"
LD-3010 90"
LD-3010 120"
2
IMPORTANT!
⁄
" wall anchors and fasteners with washers suitable for wall construction
3
8
Carrier Sets
Carrier Sleeves
Recommended
Required
1
2
2
4
2
4
3
6
7/16/2013
Carrier Arm
Basin Model #
Spacing (min.)
SL-TO1
22" (559mm)
SL-TR1
23" (584mm)
HS-TO1
27½" (699mm)
HS-TS1
19" (483mm)
HS-TR1
27½" (699mm)
Bradley • 215-1219 Rev. M; ECN 13-11-002A
Installation