Printer Installation - DNP DP-DS80D Guia De Incio Rapido

３．Printer installation
Plug the power cord (supplied)
and the USB cable, and turn
on.
* If you have to install the printer
drive, do not plug the USB cable
now.
Remove the paper cassette, and remove the paper
holders from the paper cassette.
Set the paper holders into the paper cassette.
Set it firmly all the way in.
Set the paper cassette into the printer. Rotate the paper in
the direction of the arrow to advance the leading edge
until the buzzer beeps.
When paper is correctly inserted the paper LED turns off.
Set the new ribbon into the
ribbon cassette.
Rotate the roller in the direction of
the arrow to take up the slack.
Take-up side Supply side
(white roller) (black roller)
Release the opening lever and
pull out the mechanism unit.
Set the paper roll with the
"PULL" sticker in the same
orientation as shown above.
Hold the paper
holder to prevent
it from turning
when rotating the
paper.
Install the ribbon cassette
to the printer unit.
Install the cassette so that
the supply side (black roller)
is at the front.
Lift the paper lever, raise the front cover
and remove the scrap box.
Opening lever
Paper lever
Remove packaging materials from the paper holders and set the
new paper roll.
Set the roll so that there is no gap between the paper and the holder.
Remove the "PULL" sticker attached to the roll, and rotate the
roll in the direction of the arrow to feed the paper.
Feed the paper until its edge is aligned in the middle of the two
holes (dashed line) on the paper cassette as shown in the picture
on the right.
Pay attention to feed the paper straight. If the paper is not straight,
white space may appear on the edges of the printout, the ribbon may
wrinkle, and the resister may slip.
Feed the paper
under the roller.
Set the scrap box and
close the front cover.
Note: When the mechanism unit is closed, the printer starts
paper initialization (4 blank sheets are output).
Through paper initialization, the outer layer of the paper that
may be dirty is cut off.
However, if the power is turned on after the paper is set, the
paper initialization will not start.
Front cover
Remove the ribbon cassette
from the printer unit.
Close the mechanism unit.
Scrap box