Precautions When Working With Batteries - TSM Durascrubb L75 B - LFLEXI Manual Del Usuario

• part number
WORK AND MAINTENANCE PRECAUTIONS
The machine is only suitable for cleaning floors.
The maximum gradient of operation is shown in the number-plate.
It is absolutely forbidden to suck up flammable, deflagrate, explosive, corrosive and toxic dust or liquids.
The utilization of the machine by incompetent persons is forbidden.
The machine must not be stored outdoors or in wet conditions and/or in cold conditions (under 10 °C).
Do not use steam cleaners or pressure washers to clean the machine.
Do not use the machine in the rain.
Do not fill up the solution liquid tank with the cover open.
Do not lift the machine.
If for any reasons, the protective covers are removed, they must be replaced before the machine is started
again.
Switch off the power, removing the power plug, in order to avoid unauthorized persons starting and using
the machine.
Do not start the machine if it is in need of service or repair.
Before using the machine:
• check the state and the damage of power cable; if damaged, replace the cable before using the
machine; the replacement must be performed by specialized and authorized personnel only
• check the indicators and instruments on the panel;
• check that the recovery tank is empty;
• check that the solution liquid tank is filled up;
• check that all hatches are closed and permanent (panel) and mobile (bonnet) protective covers are
in their seats, correctly fixed and in perfect conditions before the machine is started again;
• pay attention to outsiders, especially children;
• adjust the speed to the adherence conditions.
During operation:
• do not run the machine over the power cable;
• be careful when reversing in slop.
When cleaning, servicing or maintaining the machines, replacing parts, the power source must be switched
off, removing the power plug.
For transportation, fix the machine in the point of support.
TECHNOLOGICAL SYSTEMS BY MORO S.r.l. will not be held responsible for breakages, accidents, direct or
indirect damages to people or things brought about by ignorance (or non application) of the regulations for
proper use of the machine.

PRECAUTIONS WHEN WORKING WITH BATTERIES

Always wear protective clothing, provided by specific laws in force (e. g. face visor, gloves and overalls).
Remove any metallic items from hands, wrists and neck i.e. rings, chains etc. before working on batteries.
Whenever possible always use a properly designated and well ventilated area for charging:
• do not smoke nto the charging area;
• do not bring naked flames into the charging area;
• never rest tools or metallic objects on top of the battery.
When charging is complete, disconnect from the main supply.
Do not allow the batteries to become fully discharged, it may not be possible to recharge them.
Do not allow one battery to be discharged separately from the other.
Do not mix batteries from different machines.
Always recharge the batteries after use. This can be done at any time, it is not necessary to wait until they
are fully discharged.
Charge the batteries at least once a week, this will prolong battery life.
Do not store the machine with the batteries discharged.
Fill up each battery cell only after charging.
Use only distilled or demineralized water.
Add just enough water to bring up the level to the indicator range (the limits within min/max).
After the filling up replace and screw the battery caps.
Technological Systems by Moro S.r.l.
Tel.: 0434 – 598188
Pag. 7
L75 B (24 & 36V) – LFLEXI
GB
VIA NUOVA DI CORVA 94/2
33170 PORDENONE
Fax: 0434 – 510245
DURASCRUBB
(PN) – ITALIA
info@tsmitaly.com