Broan Best Instrucciones De Instalación página 6

OPERATION
Controls
Push button P1: LIGHTS. Push the button once to turn the lights ON - push a second
time to turn the lights ON to a brighter level - push a third time to turn the lights OFF.
Push button P2: MOTOR: Switch on and off the motor. Switch on the motor to the
latest used speed and if pressed different times changes the speed in a cyclic way
(1,2,3,4,1,2.....) The speed set is visualized by the icon D5 and simultaneously the
icon D8 switches on ( the speed of the rotational movement is proportional to the
speed ). To the maximum speed the icon D8 switches off and the icon D3 switches
on.
To switch off the motor, press the push button P2 for about 2 seconds (the set speed
is memorized).
Push button P3: Switch on and off the functions D4(SENSOR) and/or D7 (Air
Refresh).
Push button P4: Reset grease filters and non-ducted recirculation filters.
Icon D1: GREASE FILTERS. It switches on when the grease filter must be cleaned
(after about 30 hours of working). One time the grease filters is cleaned, to make
the hours calculation start again, press the push button P4.
Icon D3 : MAXIMUM SPEED. Is activated only when the maximum speed is set.
Icon D4: SENSOR: To activate the sensor function, press the push button P3. To
disconnect the sensor, repeat the same operation. When the sensor activated, the
hood switches on automatically in the presence of any kinds of odours or vapours,
smokes or heat, caused by the cooking process and also in the presence of possible
and anomalous gas emissions in environment.
Icons D5 and D6: DISPLAY. Shows the set speed. Shows the sensor sensitivity.
Icon D7: AIR REFRESH: To start the function Air refresh, press the button P3 (the
icon goes on);
To disconnect the function Air refresh, repeat the same operation. The function Air
Refresh activates only if the motor is not working. Starting the function Air Refresh,
the hood recycles the air in the environment in perfect silence, starting every 50
minutes (for 10 minutes, at the first speed).
Icon D8 : ENGINE ON. The icon switches on when the engine is at the first, second
or third speed. To the fourth speed, the icon switches off and the icon starts working
to the maximum speed (icon D3).
Icon D10: NON -DUCTED RECIRCULATION FILTERS (For the non-ducted
recirculation hood). It switches on when it is time to replace the non-ducted
recirculation filters (after about 120 working hours). One time the non-ducted
recirculation filters is replaced, to make the hours calculation start again press the
button P4.
Modification of sensor sensitivity:
Simultaneously press push button P3 and P4 (the sensor's sensitivity index will
appear on the display D5); press the push button P3 to change the sensor's
sensitivity (1 : minimum sensitivity / 9: maximum sensitivity). Press the push button
P4 to confirm (or is confirmed automatically after 5 seconds).
- 6 -