Yakima BigHorn 4 Manual Del Usuario página 2

Pull out the pin and
wire-lock from the
hitch plate.
TIGHTEN with 9/16" wrenches.
Safety pin and wire-lock must be in place
when bikes are loaded.
Pin is only removed for access to vehicle.
1033248D-2/15
INSTALL SAFETY PIN AND WIRE-LOCK.
• Pivot tongue to fit into hitch plate.
• Align holes and insert pin.
Install tongue.
Push the tongue into the hitch plate, aligning the holes.
• Install one of the hex bolts and a flat washer.
• Add a second washer, attach a nut.
ATTACH THE STOP BOLT
AND BOLT SLEEVE.
• Install bolt, passing through sleeve.
• Attach nut., TIGHTEN with 9/16" wrenches.
DO NOT OVERTIGHTEN!
– Bolt sleeve for
1-1/4" tongue.
REPLACE
WIRE-LOCK.