UFESA AS4000 Manual De Instrucciones página 10

1
Release the top cover latch and open the "CYCLONE"
dust container. If the container is full, empty it in
C
accordance with item
2
Remove the EPA E10 primary filter.
3
Clean EPA basic filter (13), if your filter is damaged,
you must replace it with a new one. If EPA basic filter
(13) gets dirty, you can also rinse it (13) under running
water. Remember to dry the filter before you reattach it.
For safety reasons, attaching damp
or damaged EPA E10 filter (13) is not
acceptable.
4
If necessary, clean the "CYCLONE" assembly. To do
this, remove the "CYCLONE" cartridge and module from
the dust container.
5
Detach "CYKLONE" assembly parts.
6
Rinse all parts under running water and then dry
thoroughly.
7
Put back together the "CYCLONE" dust container
parts in reverse order and close the top cover until you
hear a click.
It is recommended to replace EPA E10
basic filter (13) every 6 months of
operation.
Damaged EPA E10 filter should always
be replaced with a factory new and
original item.
"MICROFILTER" OUTLET FILTER
1
In order to replace "Microfilter" (12) press the filter
cover interlock and remove the outlet filter cover.
2
Remove the filter from the cover.
If the "Microfilter" (12) gets dirty, you can replace it with
a new one, clean or rinse it. Remember to dry the filter
before you reattach it.
For safety reasons, attaching damp or
damaged "Microfilter" is not acceptable.
3
Carefully place the new / rinsed filter in the filter
cover.
4
Place the filter cover back making sure that the two
slides located in the bottom part of the cover fit into the
slots on the vacuum' s hosing, press the cover in order
.
for the clip to lock in the hosing. The click you hear
confirms that the outlet filter cover has been correctly
attached.
Damaged "Microfilter" should always be
replaced with a factory new and original
item.
End of operation, cleaning and
maintenance
1
Switch the vacuum off by pressing ON/OFF
button (5).
2
Remove the plug from the power outlet.
3
Wind the cord by pressing cord rewind button (6).
While doing it, remember to hold the cord to make sure
it does not get tangled and the plug does not hit the
vacuum' s hosing.
4
Disconnect the telescopic tube and the nozzle or
the brush.
5
Disconnect the telescoping suction tube from the
hose. In order to remove the telescopic handle from
the hose handle, press latch "A" and pull the tube
towards the arrow.
6
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the
vacuum cleaner.
7
The vacuum cleaner may be stored in a vertical
or horizontal position. Insert the fastening hook of the
suction brush into the clip fastening the suction brush
located on the back of the vacuum, next to the power
E
cord outlet (horizontal position). The hose may stay
fastened to the vacuum cleaner, but make sure that it is
not bent too hard when stored.
8
If necessary, the vacuum' s housing and compartment
may be wiped with a wet cloth (it may be moistened with
a detergent), dried or wiped until dry.
Do not use scouring agents or solvents.
F