Technical Parameters; Static Electricity - UFESA AS4000 Manual De Instrucciones

●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.

Technical parameters

The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 80 dB(A).

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
Outlet filter cover
2
Suction brush fastening clip
3
Plug and cord
4
"CYCLONE" dust container release lever
5
ON/OFF button
6 Suction power slider
7
Cord rewind button
8
Handle
9
Slider – mechanical regulator of the suction power
10
Suction hose
11
Telescopic suction tube
12 Outlet filter "Microfilter" (fitted inside the vacuum)
13
Basic EPA E10 filter (fitted inside "CYCLONE" dust
container)
14 "CYCLONE" cartridge
15
"CYCLONE" module
16
"CYCLONE" dust container (vacuum' s removable
module)
17
Upper lid of the "CYCLONE" dust container
18
Bottom lid of the "CYCLONE" dust container
19
Combination suction brush
20
Crevice nozzle
21
Small brush
22
Small nozzle
23 Brush Natural Bristle "BNB"
(for cleaning and polishing hard, scratch-sensitive
surfaces, such as wooden floors, panels, parquet,
marble, tiles, etc.; delicate and soft natural bristle
ensures maximum effectiveness of vacuuming and
protects the surfaces cleaned against scratching).
Preparing vacuum cleaner for
operation
1
Press the side button on the end of the suction hose.
2
Place the end of the suction hose in the vacuum
cleaner. You should hear a distinctive click, if you do it
right.
3
Connect the other end of the hose (handle) with
the suction tube. In order to do it, press latch "A" and
insert the tube into the hose' s handle so that latch "A"
is blocked in opening "B".
4
Adjust the telescopic suction tube to the desired
length by sliding the slider according to the arrow and
pull the tube out/in.
A
5
Attach the selected nozzle or brush to the other end
of the suction tube.
6
Combination suction brush may be used to
vacuum hard flooring and carpets. In order to vacuum
hard surfaces - wooden, plastic floors, ceramic tiles,
etc. pull the brush out by pressing the switch on the
suction brush according to the drawing
vacuuming carpets, hide the brush (set the switch on
the suction brush to "
7
Grab the plug (3) and pull the cord out.
When pulling the power cord out, beware
of the yellow stripe signaling the end of
the cord. Persistent pulling (pulling on),
may damage the cord.
. When
").
B