LUND Tube Step Instrucciones De Instalación página 2

Installation Steps if using Lund EZ Brackets
Unless the EZ Bracket instruction sheet states otherwise, the EZ Brackets get installed on the vehicle first.
Install the EZ Brackets on the vehicle as detailed in the instruction sheet that accompanies them. Do not
yet tighten the fasteners.
1
Place Tube Step on the EZ Bracket and assemble as shown. Do not yet tighten the fasteners.
5/16-18 x 1 Square Head Bolt (Pre-installed)
Bracket Cover
5/16" Flat Washer
5/16-18 Nylock Nut
2
Tighten all fasteners to the specified torque. Fasteners that hold the
EZ Brackets to the vehicle should be tightened first, followed by fasteners
that hold the Tube Step to the EZ Brackets.
3
Tube Step
EZ Bracket
Page 2 of 4
46028
Installation Steps if using Lund OE Style No Drill Brackets
Rev A
Unless the OE Style No Drill Bracket instruction sheet states otherwise, the OE Style No Drill Brackets get
installed on the vehicle first. Install the OE Style No Drill Brackets on the vehicle as detailed in the instruction
sheet that accompanies them. Do not yet tighten the fasteners.
1
Place Tube Step on the OE Style No Drill Bracket and assemble as shown.
Do not yet tighten the fasteners.
5/16-18 x 1 Square Head Bolt (Pre-installed)
2
3
Tube Step
OE Style No Drill Bracket
5/16" Flat Washer
5/16-18 Nylock Nut
Tighten all fasteners to the specified torque. Fasteners that hold the
OE Style No Drill Brackets to the vehicle should be tightened first, followed
by fasteners that hold the Tube Step to the OE Style No Drill Brackets.
Page 3 of 4
46028
Rev A