Sundstrom SR 200 Instrucciones De Uso página 28

EN
1. Introduction
2. Use
3. Donning/Doffing
4. Maintenance
5. Technical specifications
6. List of parts
7. Key to symbols
8. Approvals
1. Introduction
The SR 200 Full face mask can be used in three different
configurations:
• Together with filters from the Sundström filter range.
• Together with fan unit SR 500/SR 500 EX or SR 700.
• Together with compressed air attachment SR 307
which then serves as a breathing apparatus with
continuous flow for connection to a compressed air
supply.
In addition, the SR 200 is available in a special version
- the SR 200 Airline - that is designed for connection to
compressed air, but is also provided with filter back-up.
The Sundström SR 200 Full-face masks provide respira-
tory and eye protection against airborne pollutants, such
as particles, micro-organisms, biochemical substances,
gases/vapours and combinations of these substances
to a user.
The respirator consists of an outer mask with polycar-
bonate or laminated glass visor that covers the user's
face, an integrated inner mask with inhalation and ex-
halation valves that covers the user's nose, mouth and
chin, a head harness with 6 mounting points that hold
the respirator in place, and a filter adapter for connecting
standard Sundström filters. The inhaled air flows through
a filter and inhalation membrane into the inner mask. Part
of the air flows past the inside of the visor in order to
prevent misting. The exhaled air is discharged from the
face piece through two exhalation valves. A wide range
of accessories are available. See section 6, List of parts.
1.2 Warnings / Limitations
Note that there can be national differences in the regula-
tions for use of respiratory protective equipment.
The equipment must not be used:
• If you cannot make the mask a tight fit during the fitting
test.
• If the ambient air does not have a normal oxygen
content.
• If the pollutants are unknown or lack adequate warning
properties.
• In environments that are Immediately Dangerous to
Life and Health (IDLH).
28
Full face mask SR 200
• With oxygen or oxygen-enriched air.
• If you find that breathing is difficult.
• If you experience dizziness, nausea or other discomfort.
• If you smell or taste the pollutants.
• If you experience any other noticeable physical effect.
• If you wear a beard or sideboards, you cannot expect
the mask to seal well.
• If you have any hair growth between the skin and
facepiece sealing surface such as stubble, beard
growth, beard, moustache, or sideburns which cross
the respirator surface.
• If scars or other physical characteristics may interfere
with a proper fit of the respirator.
• Spectacle earpieces may also give rise to leakage.
Instead of using your ordinary spectacles, have your
prescription lenses fitted into the special Sundström
spectacle frame.
• In explosive or flammable environments. Follow the
regulations that may be in force for such conditions.
If you feel uncertain about the selection and care of the
equipment, consult your work supervisor or get in touch
with the sales outlet.
You are also welcome to get in touch with the Technical
Service Department at Sundström Safety AB. Use of a
respirator must be part of a respiratory protection pro-
gram. For advice see EN 529:2005 or AS/NZS 1715:2009.
The guidance contained in these standards highlights
important aspects of a respiratory protective device
program but does not replace national or local regulations.
2. Use
2.1 Unpacking
Check that the equipment is complete in accordance
with the packing list, and that no transport damage
has occurred.
2.2 Packing list
• Full face mask
• Filter adapter
• Pre-filter holder
• Test disc
• Cleaning tissue
• ID-tag
• User instructions
2.3 Filter selection
You can identify various filters by the colour and protection
designation of the filter label.
Note. A particle filter provides protection only against
particles. A gas filter provides protection only against
gases/vapours. A combined filter protects against both
gases/vapours and particles.