EINHELL GE-CM 33 Li Solo Manual De Instrucciones página 27

A complete discharge of the battery pack will
lead to premature ageing of the battery cells.
13. Never charge the batteries unsupervised.
Protection from environmental infl uences
1. Wear suitable work clothes. Wear safety gog-
gles.
2. Protect your cordless tool and the battery
charger from moisture and rain. Moisture
and rain can cause dangerous cell damage.
3. Do not use the cordless tool or the battery
charger near vapors and infl ammable liquids.
4. Use the battery charger and cordless tools
only in dry conditions and an ambient tempe-
rature of 10-40°C.
5. Do not keep the battery charger in places
where the temperature is liable to reach over
40°C. In particular, do not leave the battery
charger in a car that is parked in the sunshine.
6. Protect batteries from overheating. Over-
loads, over-charging and exposure to direct
sunlight will result in overheating and cell
damage. Never charge or work with batteries
which have been overheated – replace them
immediately if possible.
7. Storage of batteries, battery chargers
and cordless tools. Store the charger and
your cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8. Prevent the lithium-ion battery pack from free-
zing. Battery packs which were stored below
0°C for more than 60 minutes must be dispo-
sed of.
9. When handling batteries beware of electro-
static charge: Electrostatic discharges cause
damage of the electronic protection system
and the battery cells. Avoid electrostatic char-
ging and never touch the battery poles.
Rechargeable batteries and cordless electric
Anl_SA_GE_CM_33_Li_Solo_EX_ARG.indb 27 Anl_SA_GE_CM_33_Li_Solo_EX_ARG.indb 27
GB
machines and tools contain materials that are po-
tentially harmful to the environment.
Safety instructions for hand mower
•
Before use, check the mains cable and exten-
sion cable for signs of damage and aging.
•
If the cable is damaged during operation, dis-
connect it immediately from the power supply.
•
Check the machine for signs of damage be-
fore use. Repairs may only be carried out by
our service workshop. If unusual vibrations
occur during use, switch the machine off im-
mediately and pull the plug. Check the cutters
and clean them if necessary. If the machine
continues to vibrate, switch it off, disconnect
it from the mains supply and send it to our
service workshop.
•
The machine must not be tipped whilst it is
being started. Both hands must be on the
handle when you start the machine.
•
Worn parts may only be replaced by our
service workshop. If necessary contact the
service address provided.
WARNINGS
•
Do not touch the cutters until the machine has
been disconnected from the mains and the
cutters have reached a complete standstill.
•
Break the connection with the mains supply
(in other words pull the plug out of the so-
cket):
- whenever you leave the machine unatten-
ded;
- before released a blocked cutter;
- before inspecting or cleaning and before
working on the machine;
- if a foreign body has been struck;
- whenever the machine starts to vibrate
oddly.
•
Carefully read the instructions for how to ope-
rate the machine safely.
Note
a) Read the directions with due care. Familiarize
yourself with the operator controls and proper
operation of the machine.
b) Never allow children or other persons who
are not familiar with the operating instructions
to use the mower. Contact your local govern-
mental agency for information regarding mini-
mum age requirements for the user.
c) Never mow in the direct vicinity of persons -
especially children - or animals.
d) Always keep in mind that the operator or user
of the equipment is responsible for accidents
- 27 -
28.08.2017 15:27:58 28.08.2017 15:27:58